Home › Engine / Hybrid System › 1BZ-FPE (LUBRICATION) › OIL PUMP › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073204 1BZ-FPE LUBRICATION _0356274 OIL PUMP A

1BZ-FPE LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When repairing the oil pump, the oil pan and strainer should be removed and cleaned.


PROCEDURE

Hide 1.SET NO.1 CYLINDER TO TDC/COMPRESSION

Hide 2.DRAIN ENGINE OIL

Hide 3.REMOVE DRIVE BELT(S), FAN, FLUID COUPLING ASSEMBLY AND WATER PUMP PULLEY

Hide 13901 4.REMOVE VALVE ROCKER SHAFT ASSEMBLY

Hide 11302Q 5.REMOVE CRANKSHAFT PULLEY AND TIMING GEAR COVER

Hide 6.REMOVE VACUUM PUMP AND IDLE GEAR AND CRANKSHAFT TIMING GEAR

Hide 13523 7.REMOVE CAMSHAFT TIMING GEAR

a.
A423830

Using SST, remove the mount bolt and plate washer.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A423831

Using SST, remove the timing gear.

SST
09950-40011  (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051)


Hide 11452 8.REMOVE OIL DIPSTICK AND GUIDE

a.

Remove the 2 bolts, and pull out the dipstick guide together with the dipstick from the oil pan.


b.

Remove the O-ring from the dipstick guide.


Hide 89491 9.REMOVE OIL LEVEL SENSOR

a.

Remove the 4 bolts, oil level sensor and gasket.


Hide 12101 10.REMOVE OIL PAN

a.

Remove the 17 bolts and 7 nuts.


b.
A423832

Insert the blade of SST between the stiffening plate and oil pan, and cut off applied sealer and remove the oil pan.

NOTICE:

Be careful not to damage the oil pan flange and stiffening plate.



Hide 15104 11.REMOVE OIL STRAINER AND OIL PIPE

a.
A423833

Remove the 2 bolts, 2 nuts, oil strainer and gasket.


b.

Remove the union bolt, 2 nuts, oil pipe and 3 gasket.


Hide 11429A 12.REMOVE STIFFENING PLATE

a.
A423834

Insert the blade of SST between the cylinder block and stiffening plate, and cut off applied sealer and remove the stiffening plate.

NOTICE:
·

Do not use SST for the timing gear case side and rear oil seal retainer side.

·

Be careful not to damage the stiffening plate.




Hide 11301 13.REMOVE OIL PUMP (TIMING GEAR CASE)

a.

b.
A423835

Remove the 8 bolts holding the timing gear case to the cylinder block.


c.
A423836

Using a plastic-faced hammer, lightly tap out the timing gear case and gasket.