Home › Vehicle Interior › WIPER / WASHER › REAR WIPER MOTOR
RM2850E _58 Vehicle Interior _073209 WIPER / WASHER _0356344 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  INSTALLATION  


PROCEDURE

Hide 85110R 1.INSTALL REAR WIPER MOTOR ASSEMBLY

a.

Install the rear wiper motor assembly with the 3 bolts.

Torque:

5.5 N*m (55 kgf*cm, 49 in.*lbf)



b.

Connect the connector and attach the clamp.


Hide 64735A 2.INSTALL CENTER BACK RAIL INNER GARNISH

Hide 85143R 3.INSTALL REAR WIPER MOTOR GROMMET

a.
E291313E01
2.125,0.604 2.615,1.01 true 2.667,0.958 2.979,1.156 0.313,0.198 10 false *a

Apply MP grease to the entire circumference of the lip portion of the rear wiper motor grommet.

HINT:

Do not fill the hole with MP grease. Only apply MP grease to the grooves of the lip portion.


Text in Illustration
*a Lip Portion


b.

Install the rear wiper motor grommet.


Hide 4.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

a.
E125546E09
0.646,4.01 0.646,3.604 true 2.594,3.323 1.917,3.323 true 1.479,1.604 0.885,1.76 true 0.594,4.021 0.906,4.219 0.313,0.198 10 false *a 2.656,3.26 2.969,3.458 0.313,0.198 10 false *c 0.688,1.677 1,1.875 0.313,0.198 10 false *b

When reinstalling:

i.

Clean the rear wiper arm serrations to remove any burs, dirt, etc.

NOTICE:

Do not grind down the rear wiper arm serrations.



ii.

Clean the rear wiper motor assembly pivot serrations.

Text in Illustration
*a Wire Blush
*b Rear Wiper Arm Serrations
*c Rear Wiper Motor assembly Pivot Serrations



b.

Turn the ignition switch to ON.


c.

Operate the rear wiper motor assembly and stop at the automatic stop (park) position.


d.

Turn the ignition switch off.


e.
B463148E02
0.51,2.677 0.854,3.042 true 0.292,2.438 0.604,2.635 0.313,0.198 10 false *b 0.813,3.042 1.125,3.24 0.313,0.198 10 false *a 0.292,2.719 0.604,2.917 0.313,0.198 10 false *b

Align the rear wiper arm and blade assembly as shown in the illustration and install it with the nut.

Torque:

8.0 N*m (82 kgf*cm, 71 in.*lbf)


Text in Illustration
*a Ceramic Line
*b 10 mm (0.394 in.)

HINT:

Hold the arm hinge by hand when tightening the nut.



f.

Operate the rear wiper motor assembly while spraying washer fluid on the glass. Make sure that the rear wipers function properly and the wipers do not come into contact with the vehicle body.


g.

Raise the rear wiper arm 2 times and check that the tip of the rear wiper blade is within the range shown in the illustration.


Hide 85192R 5.INSTALL REAR WIPER ARM COVER

a.

Attach the 2 claws to install rear wipe arm cover.