77377
1.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
Install the fuel filler opening lid lock retainer in the direction shown in the illustration to install it.
77030A
2.INSTALL FUEL LID W/ MOTOR LOCK ASSEMBLY
Install the bolt.
5.5 N*m (56 kgf*cm, 49 in.*lbf)
Connect the connector.
Attach the 2 claws in the illustration to install the fuel lid with motor lock assembly.
3.INSTALL WIRING HARNESS CLAMP
Install the wiring harness clamp and grommet.
Align the wiring harness clamp with the positions on the marking tape.
| *a | Marking Tape |
62611C
4.INSTALL NO. 1 SIDE TRIM BOARD RH
62516B
5.INSTALL NO. 2 SIDE TRIM BASE COVER RH
62515B
6.INSTALL NO. 1 SIDE TRIM BASE COVER RH
61705S
7.INSTALL COOLER CONDENSER AIR INTAKE COVER SUB-ASSEMBLY
Install the 8 screws and cooler condenser air intake cover sub-assembly.