76825
1.INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR
When installing the back door outside garnish protector, heat the back door outside garnish using a heat light.
| Item | Temperature |
|---|---|
| Back Door Outside Garnish | 20 to 30°C (68 to 86°F) |
Do not heat the back door outside garnish excessively.
Clean the back door outside garnish protector surface.
Using a heat light heat the back door outside garnish surface.
Remove the double sided tape from the back door outside garnish surface.
Wipe off any tape adhesive residue with cleaner.
Apply primer to the back door outside garnish protector installation area on the back door outside garnish.
Do not apply primer excessively.
Remove the peeling paper on a new back door outside garnish protector while making sure not to touch the adhesional surface.
Install the back door outside garnish protector as shown in the illustration.
| *a | Specified Installation | *b | 2.0 mm (0.079 in.) |
| *c | Installation Range | - | - |
After the primer dries (approximately 3 minutes), install the back door outside garnish protector.
Firmly press the back door outside garnish protector to attach it.
81270
2.INSTALL LICENSE PLATE LIGHT ASSEMBLY