Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for Disc Type)
RM2850E _54 Brake _073227 BRAKE (FRONT) _0356450 FRONT BRAKE(for Disc Type) G

BRAKE (FRONT)  FRONT BRAKE(for Disc Type)  INSPECTION  


PROCEDURE

Hide 1.MEASURE PAD LINING THICKNESS

C396432

Using a ruler, measure the pad lining thickness.

Standard thickness:

14.0 mm (0.551 in.)


Minimum thickness:

1.0 mm (0.039 in.)


Replace the pad as a set if the thickness is less than the minimum or if it shows sign of uneven wear.

Hide 2.MEASURE DISC THICKNESS

C397387

Standard thickness:

35.0 mm (1.378 in.)


Minimum thickness:

33.0 mm (1.299 in.)


Replace the disc if the thickness of the disc is at the minimum thickness or less. Replace the disc or grind it on lathe if it is worn unevenly.

Hide 3.MEASURE DISC RUNOUT

C396434

HINT:

Before measuring the runout, confirm that the front bearing play is within specification.

Measure the disc runout at 10 mm (0.39 in.) from the outer edge of the disc.


Maximum disc runout:

0.12 mm (0.0047 in.)


If the runout is greater than the maximum, replace the disc.

Hide 4. IF NECESSARY, REPLACE DISC

a.
C396435

Remove the torque plate from the knuckle.


b.

Remove the axle hub with the disc.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>REMOVAL


c.

Remove the disc from the axle hub.


d.

Install a new disc to the axle hub.

Torque:

167 N*m (1,700 kgf*cm, 123 ft*lbf)



e.

Install the axle hub with the disc.


f.

Install the torque plate onto the knuckle.

Torque:

Upper side bolts 245 N*m (2,500 kgf*cm, 181 ft*lbf)

Lower side bolt 265 N*m (2,700 kgf*cm, 195 ft*lbf)