1.REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
46501
2.REMOVE PARKING BRAKE DRUM SUB-ASSEMBLY
Pull the parking brake lever.
Using SST and a hammer, release the staked part of the nut.
Insert SST into the groove with the flat surface facing up.
Do not damage the tip of SST using a grinder.
Completely unstake the staked part before removing the nut.
Do not damage the threads of the output shaft.
Using a socket wrench 32 mm, remove the nut.
Using a screwdriver, remove the O-ring.
Release the parking brake lever and remove the parking brake drum.
If the parking brake drum cannot be removed easily, perform the following procedure turn the shoe adjuster clockwise until the drum turns freely.
| *a | Contract |
3.REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING
Using SST, remove the 2 parking brake shoe return tension springs on the upper side.
Remove the plate washer.
Using SST, remove the parking brake shoe return tension spring on the lower side.
46556
4.REMOVE SHOE HOLD DOWN SPRING PIN
Remove the 2 shoe hold down springs and the 2 shoe hold down spring pins.
5.REMOVE PARKING BRAKE SHOE
Remove the parking brake shoe from the parking brake plate.
Using needle-nose pliers, disconnect the No. 1 parking brake cable assembly from the parking brake shoe lever.
46506A
6.REMOVE PARKING BRAKE SHOE ADJUSTER SUB-ASSEMBLY
Remove the parking brake shoe adjuster from the parking brake plate.
46601
7.REMOVE PARKING BRAKE SHOE LEVER SUB-ASSEMBLY
Using a screwdriver, remove the 2 C-washers and the parking brake shoe lever from the parking brake shoe.