Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356689 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C120B  IG Supply Voltage Low  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
C120B Master cylinder pressure sensor power supply voltage decrease occurs or history of voltage decrease exists, and defective master cylinder pressure sensor output continues for 1 second or more.
·

Master cylinder pressure sensor output defective

·

Skid control ECU (Brake actuator assembly)

·

ABS NO. 2 fuse



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (+BS TERMINAL)
a.

Turn the ignition switch off.


b.
C399804E01
1.531,0.135 1.885,0.365 0.354,0.229 0.958,1.813 0.698,1.24 true 2.698,1.854 2.698,1.208 true 0.135,0.073 0.448,0.271 0.313,0.198 10 false *a 0.823,1.896 1.344,2.156 0.521,0.26 10 false GND1 2.552,1.917 3,2.135 0.448,0.219 10 false +BS 1.594,0.167 1.979,0.406 0.385,0.24 10 false A71

Make sure that there is no looseness at the locking part and the connecting part of the connector.


c.

Disconnect the A71 skid control ECU (brake actuator assembly) connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A71-38 (+BS) - Body ground Always 11 to 14 V
A71-38 (+BS) - A71-25 (GND1) Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))


Result:
Proceed to
OK
NG



OK

2.RECONFIRM DTC

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (+BS CIRCUIT)

2.RECONFIRM DTC
a.

Reconnect the A71 skid control ECU (brake actuator assembly) connector.



c.

Turn the ignition switch off.



Result:
Result Proceed to
DTC C120B is not output A
DTC C120B is output B



A

B