Home › Engine / Hybrid System › 1HZ (INTAKE) › TURBOCHARGER
RM2850E _51 Engine / Hybrid System _073298 1HZ INTAKE _0356955 TURBOCHARGER A

1HZ INTAKE  TURBOCHARGER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
A423237

After replacing the turbocharger assembly, pour approx. 20 cc (1.2 cu in.) of new oil into the oil inlet and turn the impeller wheel by hand to splash oil on the bearing.


PROCEDURE

Hide 1.INSTALL TURBINE OUTLET ELBOW

a.
A423238

Install a new gasket and the turbine outlet elbow with the four nuts.

Torque:

530 kg*cm (38 ft*lb, 52 N*m)



Hide 2.INSTALL NO.1 TURBO WATER PIPE

a.
A423239

Install a new gasket and the water pipe with the two nuts.

Torque:

80 kg*cm (69 in.*lb, 7.8 N*m)



Hide 3.INSTALL NO.2 TURBO HEAT INSULATOR

a.
A423240

Install the No.2 turbo heat insulator with the two bolts.

Torque:

80 kg*cm (69 in.*lb, 7.8 N*m)



Hide 4.ASSEMBLE TURBOCHARGER AND EXHAUST MANIFOLD

a.
A423241

Install a new gasket and the turbocharger to the exhaust manifold with the four nuts.

Torque:

530 kg*cm (38 ft*lb, 52 N*m)



Hide 5.INSTALL TURBOCHARGER AND EXHAUST MANIFOLD ASSEMBLY

a.
A423242

Install two new gaskets to the cylinder head.


b.
A423243

Install the turbocharger and exhaust manifold assembly with the twelve nuts.

Torque:

400 kg*cm (29 ft*lb, 39 N*m)


HINT:

Apply 330 kg*cm (24 ft*lb, 32 N*m) of torque when performing additional tightening of loosed nuts.



Hide 6.INSTALL TURBO OIL PIPE

a.
A423244

Install a new gasket and the turbo oil pipe with the two nuts.

Torque:

185 kg*cm (13 ft*lb, 18 N*m)



b.

Connect the turbo oil hose.


c.

Install two new gaskets and the union bolt of the turbo oil pipe.

Torque:

250 kg*cm (18 ft*lb, 25 N*m)



Hide 7.INSTALL TURBOCHARGER STAY

a.
A423245

Install the turbocharger stay with the three bolts.

Torque:

1,200 kg*cm (87 ft*lb, 118 N*m)



Hide 8.INSTALL TURBOCHARGER HEAT INSULATOR

a.
A423246

Install the heat insulator with the two bolts.

Torque:

185 kg*cm (13 ft*lb, 18 N*m)



Hide 9.CONNECT WATER BY-PASS HOSES

A423247

Hide 17167 10.INSTALL EXHAUST MANIFOLD HEAT INSULATOR

a.
A423248

Install the heat insulator with the five bolts.

Torque:

185 kg*cm (13 ft*lb, 18 N*m)



Hide 17113 11.INSTALL INTAKE PIPE

a.
A423249

Connect the air hose and install a new gasket and the intake pipe with the three bolts.

Torque:

200 kg*cm (14 ft*lb, 20 N*m)



b.

Connect boost compensator vacuum hose.


Hide 12.FILL ENGINE WITH COOLANT

Hide 13.START ENGINE AND CHECK FOR LEAKS