1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
58410
2.REMOVE ENGINE SERVICE HOLE COVER
58734B
3.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP
58521D
4.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
5.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
33504F
6.REMOVE SHIFT KNOB
58286
7.REMOVE NO. 1 SHIFT AND SELECT LEVER BOOT
33820B
8.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
33503F
9.REMOVE FLOOR SHIFT SHIFT LEVER SUB-ASSEMBLY
58701A
10.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
51441D
11.REMOVE NO. 1 ENGINE UNDER COVER
Remove the 6 bolts and the No. 1 engine under cover.
12.DRAIN ENGINE COOLANT
53711C
13.REMOVE FRONT FENDER APRON RH
Remove the 7 bolts and the front fender apron RH.
14.REMOVE EXHAUST PIPE ASSEMBLY
17113D
15.REMOVE NO. 1 INTAKE PIPE
Loosen the hose clamp of the intercooler air hose.
Remove the 3 bolts, 2 nuts, No. 1 intake pipe and gasket.
|
Bolt |
|
Nut |
17271
16.REMOVE NO. 1 TURBO INSULATOR
Remove the 3 bolts and the No. 1 turbo insulator.
16028
17.REMOVE NO. 2 TURBO WATER PIPE SUB-ASSEMBLY
Remove the bolt, union bolt, No. 2 turbo water pipe sub-assembly and 2 gaskets.
Remove the O-ring from the No. 2 turbo water pipe sub-assembly.
17700
18.REMOVE AIR CLEANER ASSEMBLY
Disconnect the intake mass air flow meter sub-assembly connector and disengage the clamp from the air cleaner assembly.
Loosen the hose clamp and remove the 4 bolts and air cleaner assembly.
17341F
19.SEPARATE NO. 1 AIR HOSE
Disengage the 4 clamps from No. 1 air hose.
Remove the bolt from the No. 1 air hose.
Loosen the clamp and disconnect the air hose from the No. 1 air hose.
Loosen the hose clamp and disconnect the No. 1 air hose from the turbocharger sub-assembly.
17291
20.REMOVE TURBINE OUTLET ELBOW
Remove the 2 bolts, 5 nuts, turbine outlet elbow and gasket.
|
Bolt |
|
Nut |
15407
21.REMOVE TURBO OIL INLET PIPE SUB-ASSEMBLY
Remove the bolt, 2 union bolts, turbo oil inlet pipe sub-assembly and 4 gaskets.
|
Union Bolt |
|
Bolt |
15474
22.REMOVE TURBO OIL OUTLET PIPE
Remove the 4 bolts, turbo oil outlet pipe, water drain pipe and 2 gaskets.
| *1 | Water Drain Pipe |
16027
23.REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY
Disengage the 2 wire harness clamps.
Remove the bolt, 2 union bolts, No. 1 turbo water pipe sub-assembly and 4 gaskets.
|
Union Bolt |
|
Bolt |
17201
24.REMOVE TURBOCHARGER SUB-ASSEMBLY
Disengage the 3 claws and separate the engine wire harness.
Remove the 4 nuts, 4 spacers, turbocharger sub-assembly and gasket.
Remove the 9 stud bolts.