Home › Engine / Hybrid System › 2TR-FE EXHAUST › EXHAUST MANIFOLD
RM2850E _51 Engine / Hybrid System _073296 2TR-FE EXHAUST _0356989 EXHAUST MANIFOLD A

2TR-FE EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 58410 1.REMOVE ENGINE SERVICE HOLE COVER

Hide 58734B 2.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58521D 3.REMOVE ENGINE SERVICE HOLE COVER MAT

Hide 58420 4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58123A 5.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 33506F 6.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 58701A 7.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 17861 8.REMOVE INTAKE AIR CONNECTOR

Hide 17410 9.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.

For rear exhaust type

i.

Disconnect the oxygen sensor connector.


ii.
A156778

Remove the 2 nuts and the 2 bolts, and then separate the front exhaust pipe from the catalytic with pipe converter assembly.


iii.
A156777

Remove the 2 bolts and the 2 compression springs, and then remove the front exhaust pipe with gasket from the exhaust manifold.



b.

For side exhaust type

i.
A180098

Remove the 2 nuts and the 2 bolts, and then separate the front exhaust pipe from the center pipe assembly.


ii.
A156777

Remove the 2 bolts and the 2 compression springs, and then remove the front exhaust pipe with gasket from the exhaust manifold.



Hide 17167 10.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A431296

Remove the nut and separate the shift wire clamp.


b.
A183383

Remove the 4 bolts and No. 1 exhaust manifold heat insulator.


Hide 17141 11.REMOVE EXHAUST MANIFOLD

a.
A183384

Remove the 6 nuts, exhaust manifold and gasket.