Home › Engine / Hybrid System › 2TR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM2850E _51 Engine / Hybrid System _073288 2TR-FE ENGINE MECHANICAL _0356951 DRIVE BELT G

2TR-FE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT FAN AND GENERATOR V BELT

a.
A430911E01
1.031,0.115 2.021,0.333 0.99,0.219 10 false INCORRECT

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the fan and generator V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A088652

Check that the belt fits properly in the ribbed groves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the groove on the bottom to the pulley. If it has slipped out, replace the fan and generator V belt. Install a new fan and generator V belt correctly.



c.
G038478E06
1.219,0.188 2.458,0.698 false 1.021,0.906 1.188,0.906 1.188,0.906 0.729,1.385 false 2.573,1.094 2.813,1.469 true 0.729,3.01 0.865,2.854 false 1.365,1.188 2.063,1.115 true 0.375,0.073 1.344,0.458 0.969,0.385 10 false Bracket Side Indicator 0.344,0.833 1.115,1.063 0.771,0.229 10 false Drive Belt 2.021,1.5 3.26,1.75 1.24,0.25 10 true Arm Side Indicator 0.365,3.031 1.208,3.281 0.844,0.25 10 false Tensioner 1.229,1.115 1.427,1.313 0.198,0.198 10 false A

Check that the tensioner indicator mark is within range A shown in the illustration.

If the mark is not within range A, replace the fan and generator V belt.


Hide 88310A 2.INSPECT NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

a.
A430911E01
1.031,0.115 2.021,0.333 0.99,0.219 10 false INCORRECT

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A088652

Check that the belt fits properly in the ribbed groves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the groove on the bottom to the pulley. If it has slipped out, replace the V belt. Install a new V belt correctly.



c.

Check the belt tensioner and deflection.

Click hereEngine / Hybrid System>2TR-FE (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION