Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0357042 SFI SYSTEM D

2TR-FE ENGINE CONTROL  SFI SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION FOR M-OBD


A093827

When troubleshooting Multiplex OBD (M-OBD) vehicles, the vehicle must be connected to the GTS. Various data output from the vehicle's Engine Control Module (ECM) can then be read.

The Malfunction Indicator Light (MIL) is illuminated when the vehicle's on-board computer detects a malfunction in the computer itself or in drive system components. In addition, the applicable Diagnostic Trouble Codes (DTCs) are stored in the ECM memory (Click here Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>DIAGNOSTIC TROUBLE CODE CHART). If the malfunction does not reoccur, the MIL stays ON until the ignition switch is turned to OFF, and then the MIL turns OFF when the ignition switch is turned to ON. However, the DTCs remain stored in the ECM memory.

To check the DTCs, connect the GTS to the DLC3 (Data Link Connector 3) on the vehicle or connect terminals TC and CG on the DLC3 (DTCs will be displayed in the combination meter).


NORMAL MODE AND CHECK MODE


The diagnosis system operates in "normal mode" during normal vehicle use. In normal mode, 2 trip detection logic is used to ensure accurate detection of malfunctions. A "check mode" is also available to technicians as an option. In check mode, 1 trip detection logic is used for simulating malfunction symptoms and increasing the system's ability to detect malfunctions, including intermittent malfunctions (Click here Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>CHECK MODE PROCEDURE).


2 TRIP DETECTION LOGIC


When a malfunction is first detected, the malfunction is temporarily stored in the ECM memory (1st trip). If the ignition switch is turned to OFF and then ON again, and the same malfunction is still detected again, the MIL will illuminate (2nd trip).


FREEZE FRAME DATA


The freeze frame data records the engine conditions (fuel system, calculated engine load, engine coolant temperature, fuel trim, engine speed, vehicle speed, etc.) when a malfunction is detected. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.



INSPECT BATTERY VOLTAGE


Battery voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding.


CHECK MIL


A093827

a.

The MIL illuminates when the ignition switch is turned to ON and the engine is not running.

HINT:

If the MIL does not illuminate, troubleshoot the MIL circuit (Click here Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>MIL Circuit).



b.

When the engine is started, the MIL should turn OFF. If the light remains ON, the diagnosis system has detected a malfunction or abnormality in the system.