Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0357042 SFI SYSTEM C

2TR-FE ENGINE CONTROL  SFI SYSTEM  P0116  Engine Coolant Temperature Circuit Range / Performance Problem  


DESCRIPTION

Refer to DTC P0115 (Click here Engine / Hybrid System>2TR-FE (ENGINE CONTROL)>SFI SYSTEM>P0115).

DTC No. DTC Detection Condition Trouble Area
P0116 If engine coolant temperature is between -40°C (-40°F) and 60°C (140°F) at engine start, and conditions (a) and (b) are met (2 trip detection logic):
(a) Vehicle is driven at varying speeds (under acceleration and deceleration)
(b) Engine coolant temperature remains within 3°C (5.4°F) of engine starting temperature
·

Engine coolant temperature sensor

·

Thermostat



MONITOR DESCRIPTION

The Engine Coolant Temperature sensor is used to monitor the engine coolant temperature. The engine coolant temperature sensor has a thermistor that varies its resistance depending on the temperature of the engine coolant. When the coolant temperature is low, the resistance in the thermistor increases. When the temperature is high, the resistance decreases. The variations in resistance are reflected in the output voltage from the sensor. The ECM monitors the sensor voltage and uses this value to calculate the engine coolant temperature. When the sensor output voltage deviates from the normal operating range, the ECM interprets this as a fault in the engine coolant temperature sensor and sets a DTC.

Examples:

Upon starting the engine, the engine coolant temperature is between -40°C (-40°F) and 60°C (140°F). If, after driving for 250 seconds, the engine coolant temperature still remains within 3°C (5.4°F) of the starting temperature, a DTC is set (2 trip detection logic).

CAUTION / NOTICE / HINT

HINT:
·

If DTCs P0115, P0116, P0117, and P0118 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform troubleshooting on DTC P0115, P0117 or P0118 first.

·

Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS ON.


c.

Select the following menu items: Powertrain / Engine and ECT / DTC.


d.

Read DTCs.


Result:
Display (DTC Output) Proceed To
P0116 A
P0116 and other DTCs B



A

2.INSPECT THERMOSTAT

B

2.INSPECT THERMOSTAT
a.

Remove the thermostat (Click here Engine / Hybrid System>2TR-FE COOLING>THERMOSTAT>REMOVAL).


b.

Check the valve opening temperature of the thermostat.

Standard opening temperature:

80 to 84 °C (176 to 183 °F)


HINT:

In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.



Result:
Proceed To
OK
NG



OK

NG