Home › Engine / Hybrid System › 2TR-FE (LUBRICATION) › LUBRICATION SYSTEM
RM2850E _51 Engine / Hybrid System _073292 2TR-FE LUBRICATION _0356998 LUBRICATION SYSTEM G

2TR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK ENGINE OIL LEVEL

a.

Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low and full level marks.

If the oil level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.



Hide 2.CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloring or thinning. If the oil is bad, replace the oil and oil filter.


Hide 3.CHECK OIL PRESSURE


b.
A086844

Install the oil pressure gauge.


c.

Warm up the engine.


d.

Check the oil pressure under the following conditions.

Standard oil pressure:
Condition Specified Condition
Idling 29 kPa (0.3 kgf/cm2, 4.2 psi) or more
3000 rpm 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi) or more



e.

Remove the oil pressure gauge.