The ECM continuously monitors its internal memory status, internal circuits, and output signals sent to the throttle actuator. This self-check insures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the appropriate DTC and illuminate the MIL.
The ECM memory status is diagnosed by internal "mirroring" of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The 2 CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if one of the following occurs: 1) outputs from the 2 CPUs are different and deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is found in the throttle actuator supply voltage, or 4) any other ECM malfunction is found.
| DTC No. | DTC Detection Condition | Suspected Area |
|---|---|---|
| P0604
P0606 P0607 P0657 |
ECM internal error
(1 trip detection logic) |
ECM |
Read freeze frame data using an intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the intelligent tester ON.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Display (DTC Output) | Proceed To |
|---|---|
| P0604 or P0606 or P0607 or P0657 | A |
| P0604 or P0606 or P0607 or P0657 and other DTCs | B |
If any other DTCs besides P0604, P0606, P0607 and/or P0657 are output, perform troubleshooting for those DTCs first.
A
B