This DTC is stored when the engine speed exceeds the threshold.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0219 | The engine speed is 3740 rpm or more for 0.5 seconds or more when the vehicle is being driven at a speed of 3 km/h (1.8 mph) or more and the battery voltage is 8 V or higher (1 trip detection logic). | Engine oil level |
For manual transmissions, the engine may over rev due to the way the customer shifts gears. Therefore, be sure to ask the customer about their shifting habits and give advice if the customer has mentioned that the engine over revved.
The engine may suck in an excessive amount of oil and over rev due to an increase in the engine oil level. Therefore, be sure to ask the customer about their vehicle usage and give advice if the customer has mentioned that the engine over revved.
If any other DTCs are output, perform troubleshooting for those DTCs first.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
When confirming the freeze frame data, be sure to check all 5 sets of freeze frame data.
The fourth set of freeze frame data is the data recorded when the DTC is stored.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Record the stored DTCs and freeze frame data.
This freeze frame data shows the actual engine conditions when engine stall trouble occurred.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0219 is output | A |
| DTC P0219 and other DTCs are output | B |
A
B
Inspect the engine assembly (Click hereEngine / Hybrid System>N04C-VL (ENGINE MECHANICAL)>ENGINE>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| NEXT |
NEXT