N04C-VL (ENGINE CONTROL)
ECD SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- HOW TO PROCEED WITH TROUBLESHOOTING
- CHECK FOR INTERMITTENT PROBLEMS
- BASIC INSPECTION
- REGISTRATION
- INITIALIZATION
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECM
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- CHECK MODE PROCEDURE
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- P0087, P0190, P0191, P0192, P0193
- P0088, P0627, P1229
- P0093 DTC is output when following conditions (a), (b) and (c) are all met and if difference of common rail...
- P0107, P0108
- P0112, P0113
- P0115, P0117, P0118
- P0122, P0123
- P0168, P0180, P0182, P0183
- P0201, P0202, P0203, P0204, P062D
- P0217 The engine coolant temperature is 115°C (239°F) or higher for 30 seconds or more while the engine is running...
- P0219 The engine speed is 3740 rpm or more for 0.5 seconds or more when the vehicle is being driven at a speed of 3...
- P0263, P0266, P0269, P0272
- P0335, P0339
- P0340 STA ON (2 trip detection logic): No camshaft position sensor signal to ECM while cranking for 4 seconds or...
- P0488 Condition (a) or (b) continues for more than 1 second (a) Throttle motor's activation duty is out of the...
- P0500 3 seconds or more has elapsed after STA signal is switched from on to off, conditions (a), (b), (c) and (d)...
- P0504 Conditions (a) and (b) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch ON (b)...
- P0560 Condition (a) or (b) continues (1 trip detection logic): (a) Significant decrease in battery voltage (b) Open...
- P0606, P060A, P060B
- P0610 The stored vehicle information is abnormal (1 trip detection logic).
- P0617 When conditions (a), (b) and (c) are met, positive (+B) battery voltage of 10.5 V or more is applied to ECM...
- P062F Either condition below is met (1 trip detection logic): · Injector compensation code is not registered. ·...
- P0704 No clutch switch signals to ECM despite vehicle driving with varying vehicle speed between 0 and 80 km/h. (1...
- P0724 Stop light switch remains on even when vehicle is driven in GO (30 km/h (19 mph) or more) and STOP (less than...
- P0850 No exhaust brake neutral switch signals to ECM despite vehicle driving with varying vehicle speed between 0...
- P1251 Actual turbocharger pressure is deviated 40 kPa (300 mmHg, 11.8 in.Hg) or more from the simulated target...
- P1266 The pressure limiter valve remains open for 18 seconds or more due to the suction control valve being stuck...
- P1530 Both of the following conditions (1) and (2) are met (1 trip detection logic): (1) Engine speed 10 km/h (6.3...
- P1603 2 seconds or more elapse after starting the engine, and when running, the engine stops for 0.5 seconds or...
- P1604 Both conditions are met for 2 seconds or more*1 (1 trip detection logic): - STA signal is input to the ECM. -...
- P1605 When the accelerator pedal is fully closed and the engine is idling, the speed of a specific cylinder is low...
- P1608 With the accelerator pedal fully depressed, engine output decreases for approximately 4 to 10 seconds due to...
- P1674 Open or short in exhaust brake solenoid circuit for more than 3 seconds with clutch pedal released (1 trip...
- P2120, P2121, P2122, P2123, P2125, P2127, P2128, P2138
- P2226, P2228, P2229
- Engine Difficult to Start or Stalling
- Black Smoke Emitted
- Rough Idling or Excessive Engine Vibrations
- Engine Knocking or Rattling
- Lack of Power or Hesitation
- Fuel Injection System
- ECM Power Source Circuit
- EDU Power Source Circuit
- VC Output Circuit
- Starter Signal Circuit
- Brake Override System
- MIL Circuit
DIESEL THROTTLE BODY
ECM
ACCELERATOR PEDAL
MASS AIR FLOW METER
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
ENGINE COOLANT TEMPERATURE SENSOR
MANIFOLD ABSOLUTE PRESSURE SENSOR
RELAY