Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (for 2 Connectors Type)
RM2850E _58 Vehicle Interior _073194 SUPPLEMENTAL RESTRAINT SYSTEMS _0357115 AIRBAG SYSTEM(for 2 Connectors Type) C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM(for 2 Connectors Type)  B1000/31  Center Airbag Sensor Assembly Malfunction  


DESCRIPTION

The airbag ECU assembly consists of an airbag sensor, safing sensor, drive circuit, diagnosis circuit, ignition control circuit, etc.

If the airbag ECU assembly receives signals from the airbag sensor, it determines whether the SRS should be activated.

DTC B1000/31 is stored when a malfunction is detected in the airbag ECU assembly.

DTC Code DTC Detection Condition Trouble Area
B1000/31 An airbag ECU assembly malfunction. Airbag ECU assembly

CAUTION / NOTICE / HINT

NOTICE:

After replacing the airbag ECU assembly, refer to initialization (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


PROCEDURE

1.CHECK FOR DTC
a.

Turn the ignition switch to ON, and wait at least 60 seconds.


b.

Check for DTCs (Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC B1000/31 is output A
DTC B1000/31 and other DTCs are output B


NOTICE:

If only DTC B1000/31 is output, do not clear the DTCs. Instead, immediately replace the airbag ECU assembly.


HINT:

If any DTCs other than DTC B1000/31 are output, troubleshoot those DTCs first.




A

B