Other than areas where instructions are provided, use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT SPEED SENSOR LH
Attach the guide to install the speed sensor bracket to the steering knuckle with the bolt.
18N*m ( 184kgf*cm , 13 ft.*lbf )
When installing the speed sensor bracket, do not twist the wire harness.
Install the front speed sensor LH to the steering knuckle with the bolt.
8.5N*m{ 87kgf*cm , 75in.*lbf }
Do not allow foreign matter to adhere to the tip of the speed sensor or the installation area.
Make sure not to strike or damage the sensor tip when installing it.
Do not tighten the bolt if the speed sensor is tilted.
Do not carry tools etc. with magnetic properties near the magnetic rotor.
Install the speed sensor bracket to the suspension upper arm with the bolt.
18N*m{ 184kgf*cm , 13 ft.*lbf }
When installing the speed sensor bracket, do not twist the wire harness.
Install the speed sensor bracket to the stabilizer link bracket with the bolt.
18N*m{ 184kgf*cm , 13 ft.*lbf }
When installing the speed sensor bracket, do not twist the wire harness.
Install the speed sensor bracket to the body with the 2 bolts.
| *A | for N04C-UH, N04C-VL, N04C-VQ | *B | for 2TR-FE |
18N*m ( 184kgf*cm , 13 ft.*lbf )
When installing the speed sensor bracket, do not twist the wire harness.
Connect the connector.
for RH side (N04C-UH, N04C-VL, N04C-VQ):
Install the speed sensor bracket to the body with the 2 bolts.
18N*m{ 184kgf*cm , 13 ft.*lbf }
| *a | except N04C-UH | *b | for N04C-UH |
Install the 2 clamps and connect the connector.
When installing the speed sensor bracket, do not twist the wire harness.
for RH side (2TR-FE):
Install the speed sensor bracket to the body with the 2 bolts.
18N*m ( 184kgf*cm , 13 ft.*lbf )
Install the 2 clamps and connect the connector.
When installing the speed sensor bracket, do not twist the wire harness.
2.INSTALL FRONT WHEEL
3. CHECK SPEED SENSOR SIGNAL