1.INSTALL REAR SPEED SENSOR LH
Install the rear speed sensor LH with the bolt.
8.5N*m ( 87kgf*cm , 75in.*lbf )
Do not allow foreign matter to adhere to the tip of the speed sensor or the installation area.
Make sure not to strike or damage the sensor tip when installing it.
Do not tighten the bolt if the speed sensor is tilted.
Do not carry tools etc. with magnetic properties near the magnetic rotor.
2.INSTALL REAR SPEED SENSOR RH
Use the same procedure described for the LH side.
3.INSTALL SKID CONTROL SENSOR WIRE
When installing the speed sensor bracket and clamps, do not twist the wire harness.
Attach the 3 clamps and connect the connector.
for Type A:
Attach the guide to install the speed sensor bracket with the bolt.
28N*m ( 286kgf*cm , 21 ft.*lbf )
| *a | for Type A | *b | for Type B |
for Type B:
install the speed sensor bracket with the bolt.
18N*m( 184kgf*cm , 13 ft.*lbf )
Connect the connector.
Install the speed sensor bracket with the bolt.
18N*m{ 184kgf*cm , 13 ft.*lbf }
Attach the 4 clamps and connect the connector.
Install the skid control sensor wire with the bolt.
18N*m ( 184kgf*cm , 13 ft.*lbf )
4.INSTALL REAR WHEEL
5. CHECK SPEED SENSOR SIGNAL