Power is supplied to the radio receiver assembly and microphone amplifier assembly illuminations when the light control switch is in the tail or head position.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check if the illumination for the radio receiver assembly, microphone amplifier assembly or others (hazard switch, combination meter assembly, etc.) comes on when the light control switch is turned to the head or tail position.
| Result | Proceed to |
|---|---|
| Illumination comes on for all components except radio receiver assembly. (w/ microphone amplifier) | A |
| Illumination comes on for all components except radio receiver assembly. (w/o microphone amplifier) | B |
| No illumination comes on (radio receiver assembly, hazard switch, etc.). | C |
A
B
C
Disconnect the o1 connector from the microphone amplifier assembly.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| o1-10 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| o1-16 (ILL+) - Body ground | Light control switch tail or head | 11 to 14 V |
| *a | Front view of wire harness connector
(to Microphone Amplifier Assembly) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the o2 connector from the radio receiver assembly.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| o2-7 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| o2-10 (ILL+) - Body ground | Light control switch tail or head | 11 to 14 V |
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the o2 connector from the radio receiver assembly.
Disconnect the o1 connector from the microphone amplifier assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| o2-7 (GND) - o1-1 (GND) | Always | Below 1 Ω |
| o2-10 (ILL+) - o1-15 (ILL+) | Always | Below 1 Ω |
| o2-7 (GND) - Body ground | Always | 10 kΩ or higher |
| o2-10 (ILL+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the J55 connector from the radio receiver assembly.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J55-7 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| J55-10 (ILL+) - Body ground | Light control switch tail or head | 11 to 14 V |
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG