Some vehicles are equipped with an emergency halt switch due to the conversion of the vehicle. In this case, this DTC is stored if a vehicle speed signal and emergency halt switch ON signal are input to the ECM simultaneously. If this DTC is stored, inspect and repair the emergency halt switch circuit.
Different types of emergency halt switches may be used according to the type of vehicle conversion.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P1530 | Both of the following conditions (1) and (2) are met (1 trip detection logic):
(1) Engine speed 10 km/h (6.3 mph) or more (2) STOP signal on |
·
Emergency halt switch circuit ·
Emergency halt switch ·
ECM |
Connect the GTS to DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Clear the DTCs (Click hereEngine / Hybrid System>N04C-VL (ENGINE CONTROL)>ECD SYSTEM>DTC CHECK / CLEAR).
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off, and wait for 15 seconds.
Connect the GTS to DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P1530 is output | A |
| DTC is not output | B |
A
B