Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398655 AUTOMATIC TRANSMISSION SYSTEM L

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  PRECAUTION  


PRECAUTION


NOTICE:

Perform the Reset Memory procedures (A/T initialization) after replacing the automatic transmission assembly or transmission control ECU assembly.

Click hereDrivetrain>A861E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION


HINT:

Reset Memory cannot be completed by only reconnecting the cable to the negative (-) battery terminal.



HANDLING PRECAUTIONS


CAUTION:
·
C328184


·

Do not perform a stall test if there are any people or objects near the vehicle.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328186


·

Do not perform a stall test if any wheel chocks are out of position.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328185


·

Do not perform the stall test on a slippery or low-friction surface that could allow the tires to spin.

·

The vehicle could begin moving suddenly, resulting in a serious accident.


·
C328175

Do not blow compressed air without wearing safety glasses.

·

Automatic Transmission Fluid (ATF) could enter your eyes, possibly resulting in blindness.



NOTICE:
·

Before removing components from the transmission, clean off any sand, dirt or other foreign matter present on the exterior of the transmission. Make sure that foreign matter does not contaminate the inside of the transmission when parts are removed or installed, or during disassembly and reassembly of the transmission.

·

When disassembling light alloy parts such as the case, do not pry them with a screwdriver or similar tool. Instead, tap the parts with a plastic-faced hammer to separate them.

·

Do not wear cloth gloves or use cloth to handle parts during removal, disassembly, reassembly, or installation of the transmission or other components. Instead, work with bare hands or wear nonfibrous synthetic gloves to prevent cloth fibers from entering the transmission.

·

Disassembled parts should always be arranged in order and covered with a plastic sheet or other nonfibrous material to prevent dust contamination, etc.

·

Apply Toyota Genuine ATF type T-IV to sliding surfaces and rotating parts.

·

Before installing O-rings, coat them with Toyota Genuine ATF type T-IV and be sure not to damage them.

·

Be careful not to damage the mating surfaces of components because damage to these surfaces can cause oil leaks.

·

Before applying sealant, remove all of the old sealant and thoroughly clean the surfaces with non-residue solvent.

·

Use of Toyota Genuine ATF type T-IV is recommended.

·

Do not subject parts such as sensors to any impacts. Replace parts with new ones if they are dropped or subjected to a severe blow.