READ DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed | Vehicle speed/
Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) |
·
0 km/h (0 mph): Vehicle stopped ·
No large fluctuations: Vehicle driven at a constant speed |
The speed is indicated on the speedometer. |
| Engine Speed | Engine speed/
Min.: 0 rpm Max.: 16383.75 rpm |
·
0 rpm: Ignition switch ON (Engine not running) ·
No large fluctuations: Engine running at a constant speed |
The engine speed indicates the crankshaft position sensor output level. |
| Battery Voltage | Battery voltage/
Min.: 0 V Max.: 65.535 V |
11 to 14 V: Ignition switch ON | - |
| Throttle Sensor Volt % | Absolute No. 1 throttle position sensor
Min.: 0% Max.: 100% |
·
10 to 22%: Accelerator pedal fully released ·
66 to 98%: Accelerator pedal fully depressed ·
Changes continuously: Accelerator pedal fully released to fully depressed |
- |
| Stop Light Switch | Stop light switch status/
OFF or ON |
·
OFF: Brake pedal is released ·
ON: Brake pedal is depressed |
- |
| Check Mode | Check mode status/
OFF or ON |
ON: Check mode on | - |
| SPD (NT) | Input turbine speed (NT)/
Min.: 0 rpm Max.: 12750 rpm |
·
Nearly equal to engine speed (NE): Lock-up OFF (Engine idling with shift lever in P or N) ·
0 rpm: Vehicle stopped with shift lever in R or D ·
Equal to engine speed (NE): Lock-up ON (After warming up engine) |
- |
| SPD (SP2) | Output shaft speed (SP2)/
Min.: 0 km/h (0 mph) Max.: 255 km/h (158 mph) |
·
0 km/h (0 mph): Vehicle stopped ·
No large fluctuations: Vehicle driven at a constant speed |
- |
| Shift SW Status (P Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in P ·
ON: Shift lever is in P |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| Overdrive Cut Switch | Transmission control switch (O/D switch)/
OFF or ON |
·
OFF: Overdrive permitted ·
ON: Overdrive prohibited |
- |
| Shift SW Status (R Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in R ·
ON: Shift lever is in R |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| Shift SW Status (2 Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in 2/L ·
ON: Shift lever is in 2/L |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| Shift SW Status (L Range) | First hold status/
OFF or ON |
OFF: No. 1 pattern select switch assembly (first hold switch) off and shift lever is in 2/L
ON: No. 1 pattern select switch assembly (first hold switch) on and shift lever is in 2/L |
- |
| Shift SW Status (N Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in N ·
ON: Shift lever is in N |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| Shift SW Status (D Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in D ·
ON: Shift lever is in D |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| Shift SW Status (4 Range) | Park/neutral position switch status/
OFF or ON |
·
OFF: Shift lever is not in 4 ·
ON: Shift lever is in 4 |
When the shift lever position displayed on the GTS differs from the actual position, the adjustment of the park/neutral position switch or shift cable may be incorrect.
|
| A/T Oil Temperature 1 | ATF temperature sensor value/
Min.: -40°C (-40°F) Max.: 150°C (302°F) |
·
Equal to ambient temperature: After cold soak ·
50°C (122°F) to 100°C (212°F): After stall test |
- |
| A/T Oil Temperature (External) | Temperature sensor value/
Min.: -40°C (-40°F) Max.: 150°C (302°F) |
·
Equal to ambient temperature: After cold soak ·
50°C (122°F) to 100°C (212°F): After stall test |
- |
| Lock Up | Lock up/
ON or OFF |
·
OFF: Lock-up not operating ·
ON: Lock-up operating |
- |
| Shift Status | ECM gear shift command/
1st, 2nd, 3rd, 4th, 5th or 6th |
Same as actual gear | - |