Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › ECD SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0399963 ECD SYSTEM C

N04C-WA ENGINE CONTROL  ECD SYSTEM  P2200  NOx Sensor Circuit Bank 1 Sensor 1  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2200 NOx Sensor Circuit Bank 1 Sensor 1 Diagnosis Condition:
·

Circuit open

-

Ignition switch ON

-

Power supply voltage for No. 1 nitrogen oxides sensor is in the range of 11 to 14 V.


·

Circuit short

Ignition switch ON



Malfunction Status:
·

Circuit open

Signal outside the threshold continues for more than 3 seconds.


·

Circuit short

Malfunction of short-circuit in the internal circuit of the No. 1 nitrogen oxides sensor is received from CAN data for continuous 20 seconds or more.



Malfunction Duration:
·

Circuit open

3 seconds or more


·

Circuit short

20 seconds or more.



No. 1 nitrogen oxides sensor Class A DTC stored

MONITOR DESCRIPTION

·

No. 1 nitrogen oxides sensor is controlled by the nitrogen oxides sensor controller.

·

The No. 1 nitrogen oxides sensor controller is connected via the ECM and DCU (emission control ECU assembly) through CAN communication, and it sends and receives data.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P2200 Ignition switch ON for 20 seconds or more.


CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK OTHER DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.


e.

Read the DTCs.

Result:
Result Proceed to
DTC U029D is output A
DTC U029D is not output B




A

2.REPLACE NO. 1 NITROGEN OXIDES SENSOR

B

2.REPLACE NO. 1 NITROGEN OXIDES SENSOR
a.

Replace the No. 1 nitrogen oxides sensor.

Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>NITROGEN OXIDES SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC OUTPUT
3.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

HINT:

Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.



d.

Turn the ignition switch off for 30 seconds or more.


e.

Perform the confirmation driving pattern.


f.

Turn the GTS on.


g.

Enter the following menus: Powertrain / Engine / Trouble Codes.


h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END