Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082614 N04C-WA EMISSION CONTROL _0400257 DIFFERENTIAL PRESSURE SENSOR G

N04C-WA EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89480A 1.INSPECT DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Install SST to the ECM and vehicle side ECM.

Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>TERMINALS OF ECM

SST
09843-E7010  


b.

Slide the clamp and disconnect the hose from the differential pressure sensor assembly.


c.
A404383N01
0.896,1.542 1.146,1.542 1.146,1.542 1.365,1.958 false 0.583,1.469 1.042,1.75 0.458,0.281 10 false SST

Install SST to the differential pressure sensor assembly.

SST
09992-00242  


d.

Turn the ignition switch to ON.


e.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
V70 (PEX) - M32 (E2) 0 kPa 0.75 V
20 kPa (0.2 kgf/cm2, 3 psi) 1.53 V
100 kPa (1.0 kgf/cm2, 15 psi) 4.65 V



f.

Remove SST from the differential pressure sensor assembly.


g.

Connect the hose to the differential pressure sensor assembly, and slide the clamp to secure the hose.


h.

Remove SST from the ECM and vehicle side ECM.