Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › UREA SELECTIVE CATALYTIC REDUCTION SYSTEM › from 2019.08
RM2850E _51 Engine / Hybrid System _082614 N04C-WA EMISSION CONTROL _0400651 UREA SELECTIVE CATALYTIC REDUCTION SYSTEM C

N04C-WA EMISSION CONTROL  UREA SELECTIVE CATALYTIC REDUCTION SYSTEM  P206C11  Reductant Quality Sensor Circuit Low Circuit Short to Ground  


DESCRIPTION

The urea solution quality sensor (urea sensor assembly) is connected via the ECM and DCU (emission control ECU assembly) through CAN communication, and it sends and receives data.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate Memory
P206C11 Reductant Quality Sensor Circuit Low Circuit Short to Ground Diagnosis Condition:
·

Ignition switch ON.


Malfunction Status:
·

Failure of urea solution quality sensor (urea sensor assembly) [flag] is received from CAN data.


Malfunction Duration:
·

-


Urea solution quality sensor (urea sensor assembly) Class C AdBlue consumption warning light:
Comes on
DTC stored

MONITOR DESCRIPTION

Description of malfunction

Failure of urea solution quality sensor (urea sensor assembly) is received from CAN data.


Reset condition

After having restored to the normal conditions.


CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P206C11 Ignition switch ON for 32 seconds or more.

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Urea Selective Catalytic Reduction / Trouble Codes.


e.

Read the DTCs.

Result:
Result Proceed to
DTC U02A231 is output A
DTC U02A231 is not output B




A

B

2.REPLACE UREA SOLUTION QUALITY SENSOR (UREA SENSOR ASSEMBLY)
2.REPLACE UREA SOLUTION QUALITY SENSOR (UREA SENSOR ASSEMBLY)
a.

Replace the urea solution quality sensor (urea sensor assembly).

Click hereEngine / Hybrid System>N04C-WA (EMISSION CONTROL)>UREA SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CLEAR DTC
3.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Clear the DTCs.

NOTICE:

Clear the DTCs with the engine stopped, as DTCs cannot be cleared while the engine is running.



e.

Turn the ignition switch off and wait for at least 30 seconds.


Result:
Proceed to
NEXT



NEXT

4.CHECK WHETHER DTC OUTPUT RECURS (DTC P206C11)
4.CHECK WHETHER DTC OUTPUT RECURS (DTC P206C11)
a.

Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Urea Selective Catalytic Reduction / Trouble Codes.


f.

Read the DTCs.

OK:

DTCs are not output



Result:
Proceed to
NEXT



NEXT

END