The skid control ECU (brake actuator assembly) outputs this DTC when it receives a sensor power source malfunction signal from the steering angle sensor.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1432 | Steering angle sensor power supply malfunction signal is received from steering angle sensor. | ·
ECU-B NO. 3 fuse ·
ECU-IG1 NO. 3 fuse ·
Steering angle sensor (Spiral with sensor cable sub-assembly) ·
Wire harness or connector |
Do not remove the steering angle sensor from the spiral with sensor cable subassembly.
When replacing the steering angle sensor (spiral with sensor cable sub-assembly), confirm that the replacement part is of the correct specification.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When U0073, U0124 and/or U0126 is output together with C1432, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM(w/ Brake pedal Load Sensing Switch)>U0073).
When any of the speed sensors or the yaw rate and acceleration sensor (airbag ECU assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable subassembly) may be output even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag ECU assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag ECU assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).
Turn the ignition switch off.
Remove the steering wheel and the column cover.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the J71 steering angle sensor (spiral with sensor cable sub-assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J71-6 (BAT) - Body ground | Always | 11 to 14 V |
| J71-5 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Steering Angle Sensor (Spiral with Sensor Cable Sub-assembly)) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J71-2 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Steering Angle Sensor (Spiral with Sensor Cable Sub-assembly)) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG