Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column.
(Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 2 Connectors Type)>PRECAUTION)
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for 3 Connectors Type)>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4.REMOVE STEERING WHEEL ASSEMBLY
5.REMOVE LOWER STEERING COLUMN COVER
6.REMOVE UPPER STEERING COLUMN COVER
7.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.
Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.
When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel installed.
Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral with sensor cable sub-assembly.
| *1 | Slider |
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Disconnect each connector from the spiral with sensor cable sub-assembly.
Detach the 3 claws and remove the spiral with sensor cable sub-assembly.