Home › Engine / Hybrid System › N04C-WA (FUEL) › FUEL FILTER (for Fuel Tank Side) › from 2019.08
RM2850E _51 Engine / Hybrid System _082613 N04C-WA FUEL _0400846 FUEL FILTER(for Fuel Tank Side) A

N04C-WA FUEL  FUEL FILTER(for Fuel Tank Side)  REPLACEMENT  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 23300J 2.REMOVE FUEL FILTER ASSEMBLY

a.
A345057

Disconnect the 2 connectors and 2 harness clamps.


b.
A146762

Disconnect the 2 fuel hoses.


c.
A146764

Remove the 2 bolts and fuel filter assembly.


Hide 3.DRAIN FUEL

a.

Loosen the drain plug, then drain the fuel from the fuel filter.


b.

Tighten the drain plug.


Hide 84461B 4.REMOVE LEVEL WARNING SWITCH

a.
A146765

Clamp the fuel filter in a soft jaw vise.


b.

Using pliers, remove the level warning switch.

NOTICE:

Do not damage the level warning switch.



c.

Remove the O-ring from the fuel level warning switch.


Hide 23303 5.REMOVE FUEL FILTER ELEMENT SUB-ASSEMBLY

a.
A146766E02
0.688,0.323 1.052,0.552 false 0.354,0.229 0.813,0.427 0.458,0.198 10 false SST

Using SST, remove the fuel filter element.

SST
09228-64010  


Hide 23303 6.INSTALL FUEL FILTER ELEMENT SUB-ASSEMBLY

a.
A146767

Check and clean the fuel filter installation surface.


b.

Apply fuel to the gasket of a new fuel filter element.


c.

Lightly screw the fuel filter element into place, and tighten it until the gasket comes into contact with the seat.


d.

Tighten it an additional 3/4 turn by hand.


Hide 84461B 7.INSTALL LEVEL WARNING SWITCH

a.

Install a new O-ring to the level warning switch.


b.

Apply fuel to the O-ring of the level warning switch.


c.

Install the level warning switch to the fuel filter.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 23300J 8.INSTALL FUEL FILTER ASSEMBLY

a.

Install the fuel filter assembly with the 2 bolts.

Torque:
31 N*m (316 kgf*cm, 23 ft.*lbf)


b.

Connect the 2 fuel hoses.


c.

Connect the 2 connectors and 2 harness clamps.


Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 10.RESET FUEL SYSTEM WARNING LIGHT

a.
A146770

Turn the ignition switch to ON.


b.

After turning the ignition switch to ON, connect the clogging switch connector within 3 to 60 seconds.


c.

Check that the combination meter fuel system warning light turns off.