Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › MASS AIR FLOW METER › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0403586 MASS AIR FLOW METER G

N04C-WA ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the mass air flow meter inspection according to the procedures below.

·

Only replace the mass air flow meter when the MAF value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the values using the GTS (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter while it is installed in the air cleaner case (installed on the vehicle).

·

During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.



i.

Turn the ignition switch to ON (do not run the engine).


ii.

Turn the GTS on.


iii.

Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAF.


iv.

Wait 30 seconds, and read the values on the GTS.

Standard condition:

Less than 0.89 gm/s.


·

If the result is not as specified, replace the mass air flow meter.

·

If the result is within the specified range, inspect the MAF meter.

Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION