Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0403591 MANIFOLD ABSOLUTE PRESSURE SENSOR G

N04C-WA ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89420M 1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Install SST to the ECM and vehicle side ECM.

Click hereEngine / Hybrid System>N04C-WA (ENGINE CONTROL)>ECD SYSTEM>TERMINALS OF ECM

SST
09843-E7010  


b.

Turn the ignition switch to ON.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
M51 (VC) - E77 (E4) Ignition switch ON 4.75 to 5.25 V



d.
A257922N02
1,1.49 0.583,0.896 0.583,0.896 0.448,0.896 true 0.083,0.813 0.417,1.021 0.333,0.208 10 false SST

Using a 3-way connector, connect SST (turbocharger pressure gauge) to the hose leading to the manifold absolute pressure sensor, and then measure the voltage between the terminals.

SST
09992-00242  

Standard Voltage:
Tester Connection Condition Specified Condition
E67 (PIM) - E77 (E4) When negative pressure of 40 kPa (300 mmHg) is applied 0.1 to 0.7 V
Open to atmosphere 0.8 to 1.5 V
When positive pressure of 70 kPa (0.7 kgf/cm2) is applied 1.6 to 2.3 V
When positive pressure of 199 kPa (2.0 kgf/cm2) is applied 3.0 to 3.7 V


HINT:

The figures above are from data measured at standard atmospheric pressure. Figures may be affected by factors such as altitude and climate. Standard atmospheric pressure is 101 kPa.

This decreases 1 kPa with every 100 m increase in altitude. Atmospheric pressure changes with the weather.



e.

Remove SST from the ECM and vehicle side ECM.