16371
1.INSTALL FAN PULLEY
Install the fan pulley to the engine water pump assembly.
16361
2.INSTALL FAN
Install the fan to the fluid coupling assembly with the 4 nuts.
16701
3.INSTALL FAN SHROUD SUB-ASSEMBLY
Temporarily install the fan shroud sub-assembly together with the fluid coupling assembly.
Be careful not to damage the radiator core.
Install the fan shroud sub-assembly with the 4 bolts.
Temporarily install the fluid coupling assembly with the 4 nuts.
Install the fan and generator V belt.
Click hereEngine / Hybrid System>N04C-WA (ENGINE MECHANICAL)>DRIVE BELT>INSTALLATION
Install the fluid coupling assembly with the 4 nuts.
Engage the 3 hose clamps and install the radiator reservoir hose.
32922A
4.CONNECT OIL COOLER OUTLET HOSE
| *a | Upper Side |
Connect the oil cooler outlet hose and slide the hose clamp to secure the hose.
Perform the installation with the hose clamp at the correct angle.
32921D
5.CONNECT OIL COOLER INLET HOSE
| *a | Upper Side |
Connect the oil cooler inlet hose and slide the hose clamp to secure the hose.
Perform the installation with the hose clamp at the correct angle.
16572
6.CONNECT OUTLET RADIATOR HOSE
| *a | View A |
| *b | View B |
| *c | Upper Side |
| *d | RH Side |
| *e | LH Side |
Connect the outlet radiator hose and slide the 2 hose clamps to secure the hose.
Perform the installation with the hose clamp at the correct angle.
88320
7.CONNECT COOLER COMPRESSOR ASSEMBLY
Connect the cooler compressor assembly with the 6 bolts.
Connect the connector.
88310A
8.INSTALL NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT
9.INSPECT FOR DRIVE BELT
58701A
10.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
33820B
11.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
58841A
12.INSTALL SHIFTING HOLE COVER (for Automatic Transmission)
58123A
13.INSTALL SHIFT AND SELECT LEVER SUPPORT WITH BOOTS (for Manual Transmission)
58420
14.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58734B
15.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP
58410
16.INSTALL ENGINE SERVICE HOLE COVER
58521D
17.INSTALL ENGINE SERVICE HOLE COVER MAT
18.ADD ENGINE COOLANT
19.INSPECT FOR COOLANT LEAK
51441D
20.INSTALL NO. 1 ENGINE UNDER COVER