Home › Drivetrain › CLUTCH › CLUTCH UNIT (for M15#) › 2019.08–2021.01
RM2850E _52 Drivetrain _073140 CLUTCH _0355890 CLUTCH UNIT(for M15#) A

CLUTCH  CLUTCH UNIT(for M15#)  REMOVAL  


PROCEDURE

Hide 31204 2.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY

a.

Remove the clutch release fork sub-assembly together with the clutch release bearing assembly from the manual transmission assembly.


Hide 31230 3.REMOVE CLUTCH RELEASE BEARING ASSEMBLY

a.

Remove the clutch release bearing assembly from the clutch release fork sub-assembly.


Hide 31236B 4.REMOVE RELEASE FORK SUPPORT

a.

Remove the release fork support from the manual transmission assembly.


Hide 31232A 5.REMOVE RELEASE BEARING HUB CLIP

Hide 31210 6.REMOVE CLUTCH COVER ASSEMBLY

a.

Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

C372026E01
0.813,0.99 0.563,1.333 0.563,1.333 0.74,1.01 true 3.01,0.979 2.76,1.323 2.76,1.323 2.938,1 true 5.26,1.042 5.01,1.385 5.01,1.385 5.188,1.063 true 0.229,0.052 0.469,0.292 0.24,0.24 10 false *A 2.573,0.052 2.823,0.292 0.25,0.24 10 false *B 4.938,0.083 5.188,0.333 0.25,0.25 10 false *C 0.427,1.313 0.677,1.542 0.25,0.229 10 false *a 2.625,1.313 2.875,1.573 0.25,0.26 10 false *a 4.865,1.365 5.094,1.594 0.229,0.229 10 false *a

Text in Illustration
*A for M155 with 1HZ *B for M155 with 1BZ-FPE
*C for M156 - -
*a Matchmark - -


b.

Loosen each set bolt one turn at a time until the spring tension is released.


c.

for M155 with 1BZ-FPE:

Remove the 8 bolts and clutch cover assembly.

NOTICE:

Do not drop the clutch disc assembly.



d.

except M155 with 1BZ-FPE:

Remove the 6 bolts and clutch cover assembly.

NOTICE:

Do not drop the clutch disc assembly.



Hide 31250 7.REMOVE CLUTCH DISC ASSEMBLY

NOTICE:

Keep the lining part of the clutch disc assembly, pressure plate and surface of the flywheel sub-assembly free from oil and foreign matter.


Hide 33311W 8.REMOVE INPUT SHAFT BEARING

a.
C377158N01
1.5,0.604 2.031,0.344 2.031,0.344 2.313,0.344 true 2.365,0.26 2.771,0.5 0.406,0.24 10 false SST

Remove the 2 bolts at diametrically opposite points.


b.

Using SST, remove the input shaft bearing.

SST
09303-35011