Home › Suspension › FRONT SUSPENSION › TORSION BAR SPRING › from 2019.08
RM2850E _53 Suspension _073449 FRONT SUSPENSION _0357515 TORSION BAR SPRING A

FRONT SUSPENSION  TORSION BAR SPRING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

There are left and right matchmarks on the rear end of the torsion bar springs.

Be careful not to interchange them.


C397916

PROCEDURE

Hide 48162 1. APPLY GREASE TO SPINE OF TORSION BAR SPRING

a.
C397917

Install the boot.


b.

Apply MP grease to the spline of the torsion bar Spring.


Hide 2.INSTALL TORSION BAR SPRING AND ADJUST VEHICLE HEIGHT

a.

If Using a New Torsion Bar Spring:

i.
C397914

Align the matchmarks and install the torsion bar spring to the torque arm.


ii.

Align the matchmarks and install the anchor arm to the torsion bar spring.


iii.

Install the boot to the anchor arm.


iv.
C397915

Tighten the adjusting nut so that the bolt protrusion "A" is equal to that before removal.


v.

Install the front wheel and lower the vehicle.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL>INSTALLATION


vi.
C397918

Bounce the vehicle up and down several times to allow the suspention to settle.




b.

If Using a New Torsion Bar Spring:

i.
C397920

Install the torsion bar spring to the torque arm.


ii.

Install the anchor arm to the torsion bar spring.


iii.

Connect the adjusting bolt to the anchor arm with the adjusting seat and nut.


iv.

Tighten the adjusting nut by hand until there is no play in the ancher arm adjuster seat.


v.

Measure the protruding bolt end "B".

Bolt protrusion "B":

-8 - +12 mm (-0.32 - +0.48 in.)


It the bolt protrusion "B" is not to specification, reinstall the anchor arm to the torsion bar spring.


vi.
C397921

Place matchmarks on the adjusting seat, bolt and nut.

If the bolt protrusion "B" is - values, as shown in the illustration of balloon.


vii.
C397922

Tighten the adjusting nut so that nut revolution "C" is as detailed below.

Nut revolutions "C":
For Hong Kong
For Australia (Long body)
23 turns
Others (Short body besides
Tire size 7.00R16)
21 turns
Others 18 turns


viii.

Install tha front wheel and lower the vehicle.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL>INSTALLATION


ix.
C397918

Bounce the vehicle up and down several times to allow the suspension to settle.




Hide 3.INSTALL LOCK NUT

C397923

Torque:

100 N*m (1,000 kgf*cm, 74 ft.*lbf)