Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM C

N04C-VJ ENGINE CONTROL  ECD SYSTEM  U1123  Lost Communication with Variable Nozzle Type Turbo Charger Module  


DESCRIPTION

The CAN (Controller Area Network) is a serial data communication system for real time application. It is a multiplex communication system designed for on-vehicle use that provides a superior communication speed of 500 kbps and a capability to detect malfunctions. Through the combination of the CANH and CANL bus lines, the CAN is able to maintain communication based on differential voltage.

HINT:
·

Malfunctions in the CAN bus (communication line) can be checked from the DLC3. (except when the sub bus line of the DLC3 is open.)

·

Diagnostic codes (DTCs) related to CAN communication can be checked by using the GTS.

·

The DLC3 is connected to the CAN communication line, but the CAN communication line cannot detect malfunctions in the DLC3 sub bus line.



DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U1123 Lost Communication with Variable Nozzle Type Turbo Charger Module Both of the following conditions are met:
(1 trip detection logic)

(a) Ignition switch ON

(b) No communication between ECM and turbocharger actuator for 0.7 seconds


·

Open or short in turbo actuator circuit

·

Turbocharger sub-assembly

·

CAN bus line

·

ECM


Comes on DTC stored

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses of this circuits related to this system before performing the following procedure.


PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.


Result:
Proceed to
NEXT



NEXT

2.CHECK WHETHER DTC OUTPUT RECURS (U1123)
2.CHECK WHETHER DTC OUTPUT RECURS (U1123)
a.

Turn the ignition switch off and wait for 1 minute.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / DTC.


e.

Read the DTCs.


Result:
Result Proceed to
DTC U1123 A
No output B



A

B