An injector driver assembly has been adopted to drive the injector assemblies at high speeds. The injector driver assembly has realized high-speed driving under high fuel pressure conditions through the use of a DC/DC converter sub-assembly that provides a high-voltage, quick-charging system. The ECM constantly monitors the injector driver assembly and stops the engine or cuts off fuel supply to some cylinders if an abnormal condition is detected.
After replacing the ECM, the new ECM needs registration (Click here Engine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click here Engine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| *a | Front view of wire harness connector
(to Injector Driver Assembly) |
Disconnect the injector driver assembly connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | Switch Condition | Specified Condition |
|---|---|---|
| B98-2 (+B) - B98-3 (GND) | Ignition switch ON | 11 to 14 V |
Reconnect the injector driver assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the No. 2 integration relay (Click here Engine / Hybrid System>N04C-VJ (ENGINE CONTROL)>RELAY>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the No. 2 integration relay from the No. 2 relay block and junction block assembly.
Disconnect the injector driver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-4 - B98-2 (+B) | Always | Below 1 Ω |
| B98-3 (GND) - Body ground | Always | Below 1 Ω |
| 2C-4 or B98-2 (+B) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the No. 2 integration relay from the No. 2 relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-2 - 2D-4 | Always | Below 1 Ω |
| 2E-1 - Battery | Always | Below 1 Ω |
| 2D-3 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the No. 2 integration relay from the No. 2 relay block and junction block assembly.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-3 - B104-20 (IREL) | Always | Below 1 Ω |
| 2D-2 - A56-25 (MREL) | Always | Below 1 Ω |
| A102-11 (E01) - Body ground | Always | Below 1 Ω |
| 2C-3 or B104-20 (IREL) - Body ground | Always | 10 kΩ or higher |
| 2D-2 or A56-25 (MREL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG