Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454121 CAMSHAFT POSITION SENSOR A

N04C-VJ ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301M 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




c.

Connect the camshaft position sensor connector.


Hide 58701A 2.INSTALL FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 33820B 3.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 58420 5.INSTALL NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58734B 6.INSTALL REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58410 7.INSTALL ENGINE SERVICE HOLE COVER

Hide 58521D 8.INSTALL ENGINE SERVICE HOLE COVER MAT