Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › CRANKSAFT POSITION SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454122 CRANKSAFT POSITION SENSOR A

N04C-VJ ENGINE CONTROL  CRANKSAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.

Install the crankshaft position sensor with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or does not move out of place during installation.




c.

Connect the crankshaft position sensor connector.


Hide 51441D 2.INSTALL NO. 1 ENGINE UNDER COVER