This DTC is output when it is detected that the air-fuel ratio is too rich due to a malfunction in the fuel, exhaust fuel addition injector, mass air flow meter sub-assembly, or manifold absolute pressure sensor.
Using the GTS, the freeze frame data can be checked.
Serviceability is increased by being able to check the engine operating condition when the air-fuel ratio is too rich using the freeze frame data.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P1609 | Air Fuel Ratio Too Rich | (1) All the following conditions are met
1.
Any time other than start 2.
NOx sensor (air fuel ratio sensor) is active 3.
Mass air flow meter sub-assembly is normal 4.
Manifold absolute pressure sensor is normal 5.
DPF forcible regeneration control has not been performed (2) The output value of the NOx sensor (air fuel ratio sensor) is at or above the threshold (3) Approximately several seconds (1 trip detection logic) |
·
Suction control valve sticking ·
Fuel leak ·
Fuel pressure sensor (built into common rail assembly) ·
Manifold absolute pressure sensor ·
Exhaust fuel addition injector ·
Mass air flow meter sub-assembly |
Does not come on | DTC stored |
In contrast to normal malfunction diagnosis for components, circuits and systems, DTC P1608 is used to determine the malfunctioning area from the problem symptoms and freeze frame data when the user mentions problems such as engine lack of power or hesitation.
As the DTC can be stored as a result of certain user actions, even if the DTC is output, if the customer makes no mention of problems, clear the DTC without performing any troubleshooting and return the vehicle to the customer.
If any other DTCs are output, perform troubleshooting for those DTCs first.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
When confirming the freeze frame data, be sure to check all 5 sets of freeze frame data.
The fourth set of freeze frame data is the data recorded when the DTC is stored.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Record the stored DTC and freeze frame data.
This freeze frame data shows the actual engine conditions when engine rack of power trouble occurred.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| P1609 is output | A |
| P1609 and other DTCs are output | B |
If any DTCs other than DTC P1608 are output, troubleshoot those DTCs first.
A
B