Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM C

N04C-VJ ENGINE CONTROL  ECD SYSTEM  U1122  Lost Communication with EGR Valve  


DESCRIPTION

The CAN (Controller Area Network) is a serial data communication system for real time application. It is a multiplex communication system designed for on-vehicle use that provides a superior communication speed of 500 kbps and a capability to detect malfunctions. Through the combination of the CANH and CANL bus lines, the CAN is able to maintain communication based on differential voltage.

HINT:
·

Malfunctions in the CAN bus (communication line) can be checked from the DLC3. (Except when the sub bus line of the DLC3 is open.)

·

Diagnostic codes (DTCs) related to CAN communication can be checked by using the GTS.

·

The DLC3 is connected to the CAN communication line, but the CAN communication line cannot detect malfunctions in the DLC3 sub bus line.



DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U1122 Lost Communication with EGR Valve Both of the following conditions are met:

(a) Ignition switch ON

(b) No communication between ECM and EGR valve assembly for more than 0.68 seconds


(1 trip detection logic)
·

Open or short in EGR valve assembly circuit

·

EGR valve assembly

·

CAN communication system

·

ECM


Comes on DTC stored

CAUTION / NOTICE / HINT

NOTICE:
·

After replacing the ECM, the new ECM needs registration (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>REGISTRATION) and initialization (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>INITIALIZATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.


Result:
Proceed to
NEXT



NEXT

2.CHECK WHETHER DTC OUTPUT RECURS (U1122)
2.CHECK WHETHER DTC OUTPUT RECURS (U1122)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Read the DTCs.


Result:
Result Proceed to
DTC U1122 is output A
DTC is not output B



A

B