33311W
1.INSTALL INPUT SHAFT BEARING
Using SST and hammer, install a new input shaft bearing.
After installing the input shaft bearing to the hub, make sure that it rotates smoothly.
Step 1:
Install the 2 bolts.
Insert a screwdriver through the inspection hole of the flywheel housing into the flywheel ring gear of the flywheel assembly to prevent the flywheel ring gear from turning together with the crankshaft.
Step 2:
Mark the top of each flywheel bolt head with paint.
Tighten the bolts 45° in the order shown in the illustration.
Check that the paint marks are now at a 45° angle to the top.
33311W
2.INSPECT INPUT SHAFT BEARING
Turn the input shaft bearing by hand while applying force in the rotation direction.
If the input shaft bearing is stuck or difficult to turn, replace the input shaft bearing.
The input shaft bearing is permanently lubricated and requires no cleaning or lubrication.
31250
3.INSTALL CLUTCH DISC ASSEMBLY
Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
|
Manual Transmission Assembly Side |
Insert the clutch disc assembly in the correct orientation.
31210
4.INSTALL CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
| *A | for M155 | *B | for M156 |
| *a | Matchmark | - | - |
Following the procedures shown in the illustration, tighten the 6 bolts in the order starting with the bolt located near the knock pin on the top.
19 N*m (194 kgf*cm, 14 ft.*lbf)
Following the order in the illustration, uniformly tighten the bolts.
Move SST up and down, right and left lightly, after checking that the clutch disc assembly is in the center, and tighten the bolts.
31210
5.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
Using a dial indicator with roller instrument, check the diaphragm spring tip alignment.
0.5 mm (0.0197 in.)
If the alignment is not as specified, adjust the diaphragm spring tip alignment using SST.
|
Adjust |
31236B
6.INSTALL RELEASE FORK SUPPORT
Install the release fork support onto the manual transmission assembly.
39 N*m (398 kgf*cm, 29 ft.*lbf)
47 N*m (480 kgf*cm, 35 ft.*lbf)
31232A
7.INSTALL RELEASE BEARING HUB CLIP
31204
8.INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
Apply release hub grease to the clutch release fork sub-assembly and clutch release bearing assembly contact surfaces, clutch release fork sub-assembly and push rod contact surface and release fork pivot point.
Toyota Genuine Release Hub Grease or equivalent
Install the clutch release fork sub-assembly onto the clutch release bearing assembly.
31230
9.INSTALL CLUTCH RELEASE BEARING ASSEMBLY
Apply clutch spline grease to the input shaft spline.
Toyota Genuine Clutch Spline Grease or equivalent
|
Toyota Genuine Clutch Spline Grease or equivalent |
Do not apply grease to portion A shown in the illustration.
Install the clutch release bearing assembly onto the clutch release fork sub-assembly, and then install them onto the manual transmission assembly.
After installation, move the fork forward and backward to check that the clutch release bearing assembly slides smoothly.
33110
10.INSTALL MANUAL TRANSMISSION ASSEMBLY