The procedure listed below is for the LH side.
Other than areas where instructions are provided, use the same procedure for the RH and LH sides.
1.REMOVE FRONT WHEEL
2.REMOVE FRONT SPEED SENSOR LH
Disconnect the connector.
| *A | for N04C-UH, N04C-VJ, N04C-VL, N04C-VQ | *B | for 2TR-FE |
Remove the 2 bolts and disconnect the speed sensor bracket from the body.
for RH side (N04C-UH, N04C-VJ, N04C-VL and N04C-VQ):
Disconnect the connector and 2 clamps.
| *a | except N04C-UH | *b | for N04C-UH |
Remove the 2 bolts and speed sensor bracket from the body.
for RH side (2TR-FE):
Disconnect the connector.
Remove the 2 bolts and speed sensor bracket from the body.
Remove the bolt and disconnect the speed sensor bracket from the front stabilizer link bracket.
Remove the bolt and disconnect the speed sensor bracket from the suspension upper arm.
Remove the bolt and disconnect the speed sensor bracket from the steering knuckle.
Remove the bolt and front speed sensor LH from the steering knuckle.
Prevent foreign matter from attaching to the sensor tip.