Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the LHD vehicles.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
1.REMOVE STEERING COLUMN ASSEMBLY
2.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
84340
3.REMOVE STOP LIGHT SWITCH
47101A
4.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring.
47264A
5.REMOVE PUSH ROD PIN
Remove the clip and push rod pin from the push rod clevis.
47101
6.REMOVE BRAKE PEDAL SUB-ASSEMBLY
Disconnect the connector.
Remove the bolt and disconnect the brake pedal sub-assembly.
Remove the bolt, nut and brake pedal sub-assembly from the pedal bracket sub-assembly.
47124A
7.REMOVE BRAKE PEDAL SHAFT COLLAR
Remove the 2 brake pedal bushes and collar from the brake w/ switch pedal sub-assembly.
47131
8.REMOVE STOP LAMP SWITCH CUSHION
Remove the stop light switch cushion from the brake w/ switch pedal sub-assembly.
47121
9.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad from the brake w/switch pedal sub-assembly.