1.INSPECT AND ADJUST BRAKE PEDAL HEIGHT
Inspect and adjust the brake pedal height with the floor carpet folded back.
Inspect the brake pedal height.
| *1 | Stop Light Switch Assembly |
| *2 | Push Rod |
| *a | Pedal Height |
172 to 179 mm (6.77 to 7.05 in.)
Adjust the brake pedal height.
Remove the stop light switch (Click hereVehicle Interior>LIGHTING>STOP LIGHT SWITCH>REMOVAL).
Loosen the push rod lock nut.
Adjust the pedal height by turning the pedal push rod.
172 to 179 mm (6.77 to 7.05 in.)
Tighten the push rod lock nut.
26 N*m (265 kgf*cm, 19 ft.*lbf)
Install the stop light switch (Click hereVehicle Interior>LIGHTING>STOP LIGHT SWITCH>INSTALLATION).
2.INSPECT BRAKE PEDAL FREE PLAY
Stop the engine. Depress the pedal several times until there is no vacuum in the booster. Then release the pedal.
Push in the pedal until a slight resistance is felt. Measure the distance as shown.
1.0 to 6.0 mm (0.04 to 0.24 in.)
| *a | Pedal Free Play |
Check the brake pedal free play at the same location as that used when checking the brake pedal height.
If incorrect, troubleshoot the brake system.
3.INSPECT BRAKE PEDAL RESERVE DISTANCE
Release the parking brake lever. Start the engine.
Depress the pedal and check the pedal reserve distance.
More than 45 mm (1.8 in.)
If the distance is not as specified, troubleshoot the brake system.
Check the brake pedal reserve distance at the same location as that used when checking the brake pedal height.