Home › Engine / Hybrid System › N04C-VJ (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › from 2021.01
RM2850E _51 Engine / Hybrid System _096892 N04C-VJ ENGINE MECHANICAL _0461242 REAR CRANKSHAFT OIL SEAL A

N04C-VJ ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR ENGINE OIL SEAL

a.

Apply MP grease to the rear engine oil seal lip.


b.
A265613C01
1.385,0.938 1.604,0.146 1.604,0.146 1.75,0.146 false 1.792,0.052 2.208,0.219 0.417,0.167 10 false SST 2.729,0.271 2.958,0.438 0.229,0.167 10 false *a
*a 4 mm (0.157 in.)


Using SST and a hammer, tap in a new rear engine oil seal until it is 4 mm (0.157 in.) below the upper edge of the flywheel housing.

SST
09223-78010  

NOTICE:
·

Be careful not to tap the rear engine oil seal at an angle.

·

Keep the gap between the rear oil seal retainer edge and the rear engine oil seal free of foreign matter.