1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2.DISCHARGE FUEL
25608
3.REMOVE EGR COOLER SUB-ASSEMBLY
26100
4.REMOVE DIESEL THROTTLE BODY
53712C
5.REMOVE FRONT FENDER APRON LH
23741B
6.REMOVE INJECTION PIPE CLAMP
Disconnect the connector and clamp.
Remove the 2 bolts and 2 injection fuel pipe clamps.
23802E
7.REMOVE FUEL PIPE SUB-ASSEMBLY
Remove the 2 nuts and 2 fuel pipe clamps.
Using a 17 mm union nut wrench, loosen the 2 union nuts.
Remove the fuel pipe sub-assembly.
Be sure to prevent foreign matter or water from entering the lines.
8.REMOVE INJECTION PIPE SUB-ASSEMBLY
Using a 17 mm union nut wrench, loosen the 8 union nuts and remove the injection pipe sub-assembly.
Be sure to prevent foreign matter or water from entering the lines.
23810A
9.REMOVE COMMON RAIL ASSEMBLY
|
Push |
|
Pull |
Disconnect the fuel pressure sensor connector as shown in the illustration.
Remove the union bolt and disconnect the No.4 fuel pipe.
Be sure to prevent foreign matter or water from entering the lines.
Remove the gasket
Remove the 2 bolts and fuel pipe support.
Remove the 2 bolts, common rail assembly fuel pipe support and common rail assembly.