1.CHECK TURBOCHARGER PRESSURE
| *1 | Manifold Absolute Pressure Sensor |
Using a 3-way connector, connect SST (turbocharger pressure gauge) to the hose leading to the intake manifold.
Fully apply the parking brake and chock the 4 wheels.
While depressing the clutch pedal, fully depress the accelerator pedal. Measure the boost pressure at maximum engine speed (approximately 3610 to 3690 rpm).
30 to 70 kPa (0.3 to 0.7 kgf/cm2, 4 to 10 psi)
2.INSPECT TURBOCHARGER SUB-ASSEMBLY
Remove the No. 1 turbo insulator.
Click hereEngine / Hybrid System>N04C-VJ (INTAKE)>TURBOCHARGER>REMOVAL
Check stroke
Check that the DC motor connector is properly installed.
When turning the ignition switch from ON to off, check that the variable nozzle operation link operates.
The lock nuts of the turbocharger fully open and fully closed stoppers do not loosen or tighten.
When turning the ignition switch off, the variable nozzle operation link operates as shown in the illustration.
Install the No. 1 turbo insulator.
Click hereEngine / Hybrid System>N04C-VJ (INTAKE)>TURBOCHARGER>INSTALLATION
3.INSPECT TURBOCHARGER CONTROL ACTUATOR
Check the voltage of the turbocharger sub-assembly control actuator.
Disconnect the turbocharger sub-assembly connector.
Turn the ignition switch to ON.
| *a | Front view of wire harness connector
(to Turbocharger Sub-assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1(HLV) - 2(HLG) | Ignition switch ON | 11 to 14 V |
If the voltage is not as specified, check the wire harness and connector.
4.INSPECT INTAKE SYSTEM
Check that there is no air suction or leaks at the points shown in the illustration.
| *1 | Air Cleaner Assembly | *2 | Mass Air Flow Meter Sub-assembly |
| *3 | PCV Hose Assembly | *4 | Turbocharger Sub-assembly |
| *5 | Intercooler Assembly | *6 | EGR Cooler Sub-assembly |
| *7 | Oil Separator Assembly | *8 | Diesel Throttle Body Assembly |
| *9 | Manifold Absolute Pressure Sensor | *10 | EGR Valve Assembly |
| *11 | Intake Manifold | - | - |