Before removing or installing the ignition switch assembly, make sure to turn the ignition switch to ACC.
If the ignition switch assembly is removed with the ignition switch not turned to ACC, when installed, it will not align with the position of the ignition switch lock cylinder assembly.
45287
1.REMOVE LOWER STEERING COLUMN COVER
45286B
2.REMOVE UPPER STEERING COLUMN COVER
69570
3.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
Turn the ignition switch to ACC.
Using a screwdriver, remove the ignition switch lock cylinder assembly.
84450
4.REMOVE IGNITION SWITCH ASSEMBLY
Remove the 2 screws and disconnect the keyinterlock solenoid.
Detach the clamp and disconnect the connector.
Remove the screw and the ignition switch assembly.
Do not move the removed ignition switch assembly from the ACC position.
If moved from ACC, when installed, it will not align with the position of the ignition switch lock cylinder assembly.