Before removing or installing the ignition or starter switch assembly, make sure to turn the ignition switch to ACC.
If the ignition or starter switch assembly is removed with the ignition switch not turned to ACC, when installed, it will not align with the position of the ignition switch lock cylinder assembly.
84450
1.INSTALL IGNITION SWITCH ASSEMBLY
Install the ignition switch assembly with the screw.
Attach the clamp and connect the connector.
Connect the key interlock solenoid to the upper steering column with switch bracket assembly with the 2 screws.
69570
2.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY
Check the camshaft position of the steering column with switch bracket assembly.
Check that the stopper plate is positioned as shown in the illustration.
| *a | Camshaft |
| *b | Stopper plate |
Turn the ignition switch to ACC.
Install the ignition switch lock cylinder assembly.
The ignition switch lock cylinder assembly should be installed completely.
45286B
3.INSTALL UPPER STEERING COLUMN COVER
45287
4.INSTALL LOWER STEERING COLUMN COVER